Merge pull request #1128 from dalathegreat/improvement/millis-reduction

Improvement: millis() reduction

Software/src/battery/BATTERIES.h

@@ -155,7 +155,7 @@ void setup_battery(void);
 void update_values_battery();
 
 #ifdef RS485_BATTERY_SELECTED
-void transmit_rs485();
+void transmit_rs485(unsigned long currentMillis);
 void receive_RS485();
 #else
 void handle_incoming_can_frame_battery(CAN_frame rx_frame);

Software/src/battery/DALY-BMS.cpp

@@ -156,24 +156,22 @@ void decode_packet(uint8_t command, uint8_t data[8]) {
   }
 }
 
-void DalyBms::transmit_rs485() {
+void DalyBms::transmit_rs485(unsigned long currentMillis) {
+
   static uint8_t nextCommand = 0x90;
 
-  if (millis() - lastPacket > 60) {
+  if (currentMillis - lastPacket > 60) {
+    lastPacket = currentMillis;
     uint8_t tx_buff[13] = {0};
     tx_buff[0] = 0xA5;
     tx_buff[1] = 0x40;
     tx_buff[2] = nextCommand;
     tx_buff[3] = 8;
     tx_buff[12] = calculate_checksum(tx_buff);
-
 #ifdef DEBUG_VIA_USB
     dump_buff("transmitting: ", tx_buff, 13);
 #endif
-
     Serial2.write(tx_buff, 13);
-    lastPacket = millis();
-
     nextCommand++;
     if (nextCommand > 0x98)
       nextCommand = 0x90;

Software/src/battery/DALY-BMS.h

@@ -22,7 +22,7 @@ class DalyBms : public RS485Battery {
  public:
   void setup();
   void update_values();
-  void transmit_rs485();
+  void transmit_rs485(unsigned long currentMillis);
   void receive_RS485();
 
  private:

Software/src/battery/KIA-E-GMP-BATTERY.cpp

@@ -161,7 +161,7 @@ uint16_t selectSOC(uint16_t SOC_low, uint16_t SOC_high) {
 }
 
 /* These messages are needed for contactor closing */
-unsigned long startMillis;
+unsigned long startMillis = 0;
 uint8_t messageIndex = 0;
 uint8_t messageDelays[63] = {0,   0,   5,   10,  10,  15,  19,  19,  20,  20,  25,  30,  30,  35,  40,  40,
                              45,  49,  49,  50,  50,  52,  53,  53,  54,  55,  60,  60,  65,  67,  67,  70,
@@ -1100,7 +1100,7 @@ void transmit_can_battery(unsigned long currentMillis) {
     }
 
     if (messageIndex >= 63) {
-      startMillis = millis();  // Start over!
+      startMillis = currentMillis;  // Start over!
       messageIndex = 0;
     }
 
@@ -1131,9 +1131,6 @@ void transmit_can_battery(unsigned long currentMillis) {
 void setup_battery(void) {  // Performs one time setup at startup
   strncpy(datalayer.system.info.battery_protocol, "Kia/Hyundai EGMP platform", 63);
   datalayer.system.info.battery_protocol[63] = '\0';
-
-  startMillis = millis();  // Record the starting time
-
   datalayer.system.status.battery_allows_contactor_closing = true;
   datalayer.battery.info.number_of_cells = 192;  // TODO: will vary depending on battery
   datalayer.battery.info.max_design_voltage_dV = MAX_PACK_VOLTAGE_DV;

Software/src/devboard/wifi/wifi.cpp

@@ -73,7 +73,7 @@ void wifi_monitor() {
 #endif
       // Try WiFi.reconnect() if it was successfully connected at least once
       if (hasConnectedBefore) {
-        lastReconnectAttempt = millis();  // Reset reconnection attempt timer
+        lastReconnectAttempt = currentMillis;  // Reset reconnection attempt timer
 #ifdef DEBUG_LOG
         logging.println("Wi-Fi reconnect attempt...");
 #endif